© 2010 American Honda Motor Co., Inc. – All Rights Reserved. BII 45155 (1011) 11 of 18
If the vehicle is equipped with a vehicle harness, continue
with step 49; if not, go to step 44.
Without Vehicle Harness
44. Plug the buzzer harness 2-pin connector to the
backup sensor harness 2-pin connector.
45. Secure the backup sensor harness to the vehicle
panel with two wire ties.
46. Bundle the excess buzzer harness, and secure it
and the 2-pin connectors with urethane tape as
shown.
FRONT
BUZZER
HARNESS
2-PIN
CONNECTOR
BUZZER
VEHICLE
PANEL
BACKUP SENSOR
HARNESS 2-PIN
CONNECTOR
BACKUP
SENSOR
HARNESS
2 WIRE
TIES
FRONT
URETHANE
TAPE
2-PIN
CONNECTORS
BUZZER
HARNESS
BUZZER
HARNESS
Bundle the
excess.
URETHANE
TAPE
BUZZER
47. Using isopropyl alcohol on a shop towel, thoroughly
clean the area where the aluminum tape will attach.
48. Using scissors, cut one aluminum tape in half.
Secure the buzzer harness and 2-pin connectors to
the vehicle panel with one piece of aluminum tape.
Go to step 52.
ALUMINUM
TAPE
FRONT
2-PIN
CONNECTORS
BUZZER
HARNESS
URETHANE
TAPE
VEHICLE
PANEL
ALUMINUM TAPE
Cut in half.
Commentaires sur ces manuels